1. Do not suddenly push the lifting handle to the "lowering position" during full load lifting.
If this operational error occurs, the carriage will suddenly rush down, causing a significant impact on the frame and even causing accidents. Therefore, the above operations should be avoided as much as possible. If there are special circumstances that require careful operation, the landing speed should be slowed down as much as possible, and the carriage must not be suddenly dropped to the bottom.
2. Do not use heavy lifting vehicles - heavy braking for unloading.
Due to the high inertia force of the vehicle during heavy lifting (usually 5-20 times the rated lifting force), it is easy to cause permanent deformation of the frame, welding of the carriage and subframe, burning of the oil pump or damage to the sealing ring, damage to the hydraulic cylinder, and other damages. The service life of the vehicle is reduced, and in severe cases, overturning accidents may occur. Therefore, it is generally prohibited to drive a dump truck when it is lifted.
3. After unloading, the dump truck must disconnect the power take-off before driving.
If this operation error occurs, during the driving of the dump truck, due to the power take-off being in the "engaged" position, the lifting oil pump will operate at high speed and no load for a long time in the "small cycle" state. Causes the hydraulic oil temperature to rise rapidly, which can easily cause damage to the oil pump oil seal and even cause the oil pump to "burn out"; More seriously, the operation of the oil pump means that the hydraulic system has a power source, which is prone to accidents where the carriage automatically rises during driving.
4. The power take-off cannot be in the "on" position during driving.
If it is in the "on" state (with a red light on), the oil pump will continue to rotate, and the hydraulic system will have a power source. This will cause the carriage to automatically lift due to misoperation on the pneumatic control valve; At this point, even if the pneumatic distribution valve is in the "down" position, oil still needs to enter the oil pump, which will cause the oil pump to burn out.
Aug 14, 2023
Leave a message
Operating procedures for dump trucks
Send Inquiry




